Replacing a crawlspace dehumidifier

Treat replacement as a new configuration check. An existing unit leaving the space does not prove a different unit can use its drain and clearances.

Illustration of two generic cabinets, measuring tape and an access opening for replacement planning.
Illustrated planning concept. No specific model or installation is depicted.
On this page

Identify the unit you have

Record the nameplate model and part number, refrigerant, power requirements and the manual supplied with the equipment. A familiar marketing name may span different revisions.

The current Compact70 record is scoped to part 4044110. Its evidence must remain separate from older Compact70 versions. Retain photos and the old manual when asking an installer about a replacement.

Measure the whole route

Record access to the location, the installed bay, filter-removal space, drain outlet and service access. Separate cabinet dimensions from fittings and supports. The E070W specification excludes feet, filter doors and collars from its nominal cabinet measurements.

Recheck the drain configuration

Record whether the old setup uses gravity or a pump and which parts will be reused. Confirm that the new equipment's manual supports the proposed arrangement. A pump's stated maximum lift does not describe flow through every hose route.

Take the worksheet and exact model documents to the installation discussion. Use the configuration cost guide to keep reused parts and new purchases separate.

Keep an ownership record

Sources and limitations

Santa Fe Compact70 product documentation Checked 2026-11-11

Santa Fe · Document date: not established · Primary source

Product specifications

Unit Dimensions 12"W x 12"H x 21"D

Product specifications

65°F and 60% RH Water Removal 43.7 Pints/Day

Product specifications

70 Pints

Product specifications

8.75 Gallons @ 80°F and 60% RH

Product specifications

4044110

Documentary evidence for the named model and revision. Checked date records retrieval. Each excerpt identifies its section or page; drawing transcriptions are labelled separately.

View source reference ↗
Santa Fe Compact70 installation and operating manual Checked 2026-11-11

Santa Fe · Document date: April 2026 · Primary source

Document revision: TS-2081 · 04/26 · Revision C

Page 3, safety instructions

Maintain a minimum 1ft. (.3m) clearance to avoid obstructing the air return and supply.

Page 5, top-view clearance diagram · Diagram transcription

11 inches at return air A for filter removal and airflow; 24 inches at supply air B for airflow.

Page 4, registrations and certifications table, individual model number

4044110

Documentary evidence for the named model and revision. Checked date records retrieval. Each excerpt identifies its section or page; drawing transcriptions are labelled separately.

View source reference ↗
AprilAire E070W specification sheet Checked 2026-11-11

AprilAire · Document date: July 2025 · Primary source

Document revision: Form No. 1013 · 325436 · 07.25

Page 1, specifications and footnotes

@ 73°F/60% RH 53 ppd

Page 1, specifications and footnotes

@ 80°F/60% RH 70 ppd

Page 2, accessory section heading

Optional Accessories

Page 2, optional condensate pump

Model 4856

Page 2, Model 4856

Condensate Pump

Page 2, Model 4856

22 ft. lift

Page 1, footnote 2 (continues in next excerpt)

Height does not include adjustable feet. The width excludes the filter doors and length

Page 1, continuation of footnote 2

excludes the duct collars.

Page 2, upper side-view drawing · Diagram transcription

32.84 inches across both collars; 24.84 inches across the cabinet; each collar extends 4.00 inches.

Documentary evidence for the named model and revision. Checked date records retrieval. Each excerpt identifies its section or page; drawing transcriptions are labelled separately.

View source reference ↗

Documentary comparison. Confirm the exact model, configuration and installation requirements before ordering.